Anker PowerCore+ 13400
On the plus side, it still works and I get to peek inside
So what happened, did you drop it?. Sorry for our loss though, never fun when our toys break
Yes, I dropped it. I think crazy glue will fix it.
Get some plastiweld or the 5 second plastic glue fix…the one that comes with the uv light to cure it.
$2 on AliExpress. Glue pen + UV light. Not bad!
RIP
Might as well do a tear down vid now
Good excuse to buy a fancy new one
I would, but it still works…for now
Glue and pray!
Okay. I fixed it. It’s better now because it has a little bubble that acts as a cushion in case I drop it again
Scroll down for picture.
.
.
.
.
.
.
.
.
.
.
.
.
.
nooo…at least it still work with a little patch work
I was being sarcastic…it’s hideoussss.
Dropping it also removed the outer sleeve?
be aware that some glues like superglue will dissolve some plastic parts (most plastics are not prone to this but a very rare breed is there). Try it on a small part before using everywhere.
Yikes! Well, at least it still works. Now, that’s Anker tough
Yep, do a JerryRig version…stanley knife & all
Oh no! Sorry about that. As long as it works…
I had almost the same thing happen to me. I went out and bought a bottle of super glue (I recommend the kind that brushes on). I let it sit for a few hours and it’s almost as good as new now.